5-45
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
addtoneplan
addtoneplan
To add a provisional tone plan to the current VISM card, use the addtoneplan command in the VoIP
switching/trunking and switched AAL2 PVC operating modes.
addtoneplan tonep-region tonep-version tonep-file
Syntax Description
Command Modes VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines You must complete the following steps before using this command:
Step 1 Place the new tone plan in the TFTP server /TFTPBOOT directory.
Step 2 Use the adddn command to add the TFTP server domain name to the VISM card.
Step 3 Use the adddnip command to add the IP address of the TFTP server domain name.
Step 4 Use the cnftftpdn command to configure the parameters of the TFTP server domain name.
The addition and configuration of the TFTP domain name is complete. You can now use the
addtoneplan command.
Note Provisional tone plans are those that you create. Built- in, or prec on figured, tone plan s ca nnot be
added with this command. Built-in tone plans are added to the system automatically upon boo t up.
You can add a maximum of 32 provisional tone plans to the system. You must create provisional tone
plan files with the following format:
System Section
version 1
description “Tone Plan defined for xxxx”
Tone Section
dial_tone 1, 2, 3, 4, 5, 6, 7
busy_tone 1, 2, 3, 4, 5, 6, 7, 8, 9, 0
stutter_tone 1, 2, 3
dtmf_digit 1, 2
tonep-region Tone plan country or region which you want to add to VISM. It can be in the
range from 1 to 64 alphanumeric characters and can contain underscores ( _ ).
This value is case sensitive.
tonep-version Tone plan version number of the tone plan country or region you a re adding to
VISM. It can be in the range from 1 to 65535.
tonep-file Tone plan file name (names are located in the TFTP server /TFTPBOOT
directory). It can be in the range from 1 to 32 alphanumer ic ch aract ers a nd c an
contain underscores ( _ ), dashes ( - ), and dots ( . ).