5-426
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dspsesset
dspsesset
To display configuration data about a specified Primary Rate Interface (PRI) backhaul session set, use
the dspsesset command in the VoIP switching/trunking and switched AAL2 PVC operating modes.
dspsesset set-num
Syntax Description
Command Modes VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the configuration data for PRI backhaul session number 1 is
displayed:
dspsesset 1
vismSessionSetNum: 1
vismSessionSetState: Idle
vismSessionSetTotalGrps: 2
vismSessionSetActiveGrp: 0
vismSessionSetFaultTolerant: FT
vismSessionSetSwitchFails: 0
vismSessionSetSwitchSucesses: 0
Related Commands
set-num In the range from 1 to 16.
Note Currently, only session set number 1 is supported.
Command Description
addsesset Adds a PRI backhaul session set between a VISM card and a call agent.
delsesset Deletes a PRI backhaul session set.