5-214
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfsrcppeer
cnfsrcppeer
To configure the port for the call agent configured with the Simple Resource Control Protocol
(SRCP)—when SRCP is the selected protocol for communication between the VISM card and call agent,
use the cnfsrcppeer command in the VoIP switching/trunking operating mode.
cnfsrcppeer peer-num udp-port-num
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines If you do not use this command, the default MGCP/SGCP port number, 2428, is used for the
upd-port-num argument value.
Examples The following example shows that peer identification number 2 is configured with UDP port number
1160:
cnfsrcppeer 2 1160
Related Commands
peer-num Peer (call agent) identification number. It can be a value from 1 to 8.
udp-port-num User Datagram Protocol (UDP) port number. It can be in the r an ge f rom 1 025 to
65535.
Command Description
addmgcgrpentry Configures call agents as part of an MGC redundancy group and assigns a
priority value for a call agent.
addmgcgrpprotocol Associates a call agent redundancy group to a gateway control protoco l.
cnfmgcgrpentry Modifies the call agent priority level of a call agent within a call agent
redundancy group.
cnfmgcgrpparam Modifies a call agent redundancy group state change notification policy
and priority level.
cnfsrcppeergrpparam Modifies the SRCP heartbeat interval and maximum UDP size for a
specified call agent redundancy group.
delmgcgrpentry Deletes a call agent from a call agent redundancy group.
delmgcgrpprotocol Deletes an MGCP from a specified call agent redundan cy group .
dspmgcgrpparams Displays all configured call agent redundancy group parameters.
dspmgcgrpprotocols Displays all configured call agent redundancy group protocols.
dspmgcgrps Displays all configured call agent redundancy groups.
dspsrcppeergrpparams Displays the SRCP parameters for all call agent redundancy groups that
have SRCP added.