5-456
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dspvismparam
dspvismparam
To display VISM card configuration parameters, use the dspvismparam command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
dspvismparam
Syntax Description This command has no arguments or keywords.
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the configuration parameters of the current VISM card are displayed:
dspvismparam
VISM mode: voipSwitching
VISM features Bit Map: 0x5ac
CAC flag: enable
DS0s available: 192
Template number: 2
Percent of functional DSPs: 100
IP address: 64.68.2.1
Subnet mask 255.255.255.252
RTCP report interval: 1000 msec
RTCP receive multiplier: 3
RTP receive timer: disable
ControlPrecedence/Tos: 0x60
BearerPrecedence/Tos: 0xa0
Aal2 muxing status: disable
Tftp Server Dn TFTPDOMAIN
Aggregate Clipping enable
Aggregate Svc Bandwidth 0
Codec negotiation option 1
Profile negotiation option 1
VAD Duty Cycle 61
VAD Tolerance 100
CALEA: enable
Note The DS0 available parameter value is applicable to AAL2 trunking operating mode only. The RTCP
report interval, RTP receive timer, ControlPrecedence/Tos, and BearerPrecedence/Tos parameter
values are applicable to VoIP switching/trunking operating mode only.
Related Commands Command Description
addcon Adds a PVC connection between a VISM card and any SM or PXM card.
cnfcac Enables or disables the CAC feature on a VISM card.
cnfcalea Enables or disables the CALEA feature on the current VISM card.