5-152
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfgwoos
cnfgwoos
To configure an in-service VISM card to the out-of-servic e state, u se the cnfgwoos command in the V oIP
switching/trunking and switched AAL2 PVC operating modes.
cnfgwoos oos-method
Syntax Description
Command Modes VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines Associated call agents are notified of VISM card state changes with an RSIP notification.
Examples The following example shows that the current VISM card is placed in the out-of-se rvice state forcef ully :
cnfgwoos 2
The VISM card prompt terminates with an s to indicate the out-of-service (standby) state:
NODENAME.1.9.VISM8.s
Related Commands
oos-method VISM card’s method of reaching the out-of-service state. It can be one of the
following values:
•2 = Forceful . Existing connections are deleted and the VISM card transitions to the
“commandedOutOfService” state. New connection requests are rejected.
•3 = Graceful. Existing connections are not released and allowed to terminate
naturally. Immediately after this command is executed, the VISM card transitions
to the “pendingOutOfService state”. New connection requests are rejected. The
VISM card transitions to the ‘commandedOutOfService’ state only when all
ongoing connections are deleted by the call agent.
Command Description
cnfgwis Configures an out-of-service VISM card to the in-service state.
dspgwstate Displays the current user-configured service states of the gateway.