5-266
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
delport
delport
To delete the VISM port on the packet network side, use the delport command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
delport
Syntax Description This command has no arguments or keywords.
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines You should execute this command before you remove the VISM card.
Caution If you remove a VISM card with an undeleted port, subsequent cards insert ed into the same slot may
not operate correctly. You should delete the resource partition and all PVCs before deleting the port.
When you use this command, the entry with the following port numbers is deleted in the following
manner:
•Entry 1 is deleted from a PXM1 card
•Entry 255 is deleted from a PXM1E card
Examples The following example shows that the VISM port on the pa cket ne twork si de i s dele te d:
delport
Related Commands Command Description
dspport Displays data about the virtual port that was created using the addport command.