5-473
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dspxgcpendpt
dspxgcpendpt
To display the attributes associated with an endpoint added using the addendpt command, or the SNMP
equivalent, use the dspxgcpendpt command in the VoIP switching/trunking and switched AAL2 PVC
operating modes.
dspxgcpendpt line-num ds0-num
Syntax Description
Command Modes VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines An endpoint added with the addendpt command is considered an xGCP endpoint even though a call
agent established connection cannot be associated w it h the en dpoin t.
Examples The following example shows that the statistics for the endpoint identified by line number 1, DS0
number 1 are displayed:
dspxgcpendpt 1 1
*********************************************************
Attributes of Endpoint Name: vism/T1-1/1
*********************************************************
Line Number = 1
Endpoint Number = 1
Endpoint Name = vism/T1-1/1
Continuity Test = FALSE
Echo Cancellation = FALSE
Protocol Version = Invalid Protocol
MGC IP Address = Unknown
MGC UDP Port = 0
Port in Notified Entity = FALSE
Request ID = 0
Quarantine Handling =
Requested Event List =
Signal Event List =
Accumulated Event List =
Quarantined Event List =
Detect Event List =
Accumulated Dialed String =
DSP Channel Connected to Network Endpoint = FALSE
Retry Count = 3
Minimum Retry Timeout = 500 ms
Maximum Retry Timeout = 500 ms
line-num Line number of the endpoint for which you want to display the attributes. It can be in
the range from 1 to 8.
ds0-num DS0 number of the endpoint for which you want to display the attr ibutes. It can be a
value from one of the following ranges:
•1 to 24 for T1 lines
•1 to 31 for E1 lines