5-368
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dsplnendptstatus
dsplnendptstatus
To display the status of endpoints for a specified T1 or E1 line, use the dsplnendptstatus command in
the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating mode.
dsplnendptstatus line-num
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the status for the endpoints on line 1 are displayed:
dsplnendptstatus 1
ds0# Endpt# Codec VAD ECAN
------------------------------
1 1 G.711a ON ON
Related Commands
line-num Line number for which you want to display the status of endpoints. It can be in the
range from 1 to 8.
Command Description
dspendpts Displays information about all the endpoints on a VISM card.
dspln Displays the characteristics of a VISM card line.