5-264
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
delmgcgrpprotocol
delmgcgrpprotocol
To delete a Media Gateway Control Protocol (MGCP) from a specified call agent redundancy group, use
the delmgcgrpprotocol command in the VoIP switching/trunking and switched AAL2 PVC operating
modes.
delmgcgrpprotocol mgc-group protocol-num
Syntax Description
Command Modes VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that protocol number 2 is delete d f rom ca ll age nt r ed undancy gro up
number 3:
delmgcgrpprotocol 3 2
Related Commands
mgc-group Call agent redundancy group number. It can be in the range from 1 to 8.
protocol-num Protocol number. It can be one of the following values:
•1 = MGCP 0.1
•2 = SGCP 1.1+
•3 = SRCP 1.0.2
•4 = SGCP 1.5
•5 = MGCP 1.0
In the range from 6 to 8, as displayed by the dspmgcgrpprotocols command.
Command Description
addmgcgrpentry Configures call agents as part of an MGC redundancy group and assigns a
priority value for a call agent.
addmgcgrpprotocol Associates a call agent redundancy group to a gateway control protoco l.
cnfdisctimers Specifies the wait delay times for the disconnected procedure, restart in
progress command—initial, minimum, and maximum timer values.
cnfmgcgrpentry Modifies the call agent priority level of a call agent within a call agent
redundancy group.
cnfmgcgrpparam Modifies a call agent redundancy group state change notification policy
and priority level.
cnfmgcgrpprotocol Configures call agent group protocol data.
cnfsrcppeer Configures the SRCP parameters when SRCP is the selected protocol for
communication between the VISM card and call agent.