4-6
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter4 Configuring VISM Features
Configuring VISM Features
Configuring VISM Features
The CLI allows you to configure all features and functions of VISM. Con figure m anda tory c omma nds
when you require argument values that are different from the default. Con figure o pti onal com ma nds
when necessary.
Perform the following tasks with CLI commands to enable your VISM card applications:
1. Perform the mandatory initial VISM configuration.
2. Perform the initial card-level configuration.
3. Configure the TDM side.
4. Configure bearer processing.
Note Configure one type of signaling—CAS or CCS—for each application.
5. Configure the ATM network side.
6. Configure the call agent interface.
Note If you are using a VoIP or an AAL2 trunking application, do not configure a call agent
interface.

Initial VISM Configuration

You must execute a sequence of mandatory commands, specific to your operating mode, to make the
VISM card fully operational. The mandatory commands for each operating mode are listed in Tabl e 4-2
in order of execution. The remainder of this chapter assists you with using these commands, and
commands specific to your operating system.