4-5
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter4 Configuring VISM Features
Connecting to Cisco MGX 8000 Series Platforms
1.17 Empty Clear
1.18 Empty Clear
1.19 Empty Clear
1.20 Empty Clear
1.21 Boot VISM-8T1 Clear
1.22 Empty Clear
1.25 Reserved VISM-8E1 Clear
1.26 Empty Clear
1.27 Empty Clear
1.28 Active VISM-8E1 Clear
1.29 Empty Clear
1.30 Empty Clear
1.31 Empty Clear
1.32 Empty Clear
NODENAME.1.7.PXM.a >
Step 8 Identify, from the list displayed in Step 7, the slot number of the VISM card you want to configure.
Step 9 Type the cc command (to change card), th e VISM ca rd slo t num ber ide ntif ied i n Step 8 , and pres s Enter.
The VISM card prompt is displayed. See the “VISM Card Prom pt ” se cti on on pa ge 4-5 for more
information.
You have completed logging in to the PXM and VISM cards and can now perform the mandatory initial
VISM card configuration. Proceed to the “Initial VISM Configuration” section on page 4-6.

VISM Card Prompt

The VISM card prompt is displayed when you successfully log in to a VISM card and has the foll owing
format:
NODENAME.1.9.VISM8.a
The VISM card prompt contains the following data:
Name of the MGX 8000 Series platform to which you are c onnec te d
Number of the shelf—always 1
Slot number
Card type
Card state—active (a) or standby (s)
Logging Out of VISM and PXM Cards
Enter one of the following commands to log out of the VISM and PXM cards:
bye
logout