5-173
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnflnsig
cnflnsig
To configure the signaling mode for a VISM card line, use the cnflnsig command in the AAL2 trunking
operating mode.
cnflnsig line-num line-signal-type
Syntax Description
Command Modes AAL2 trunking
Usage Guidelines You are required to confirm your entry when using this command to ensure that the signaling type is not
changed while endpoints are configured for the line in dic at ed by th e line-num argumen t.
This command is not allowed when CIDs or CCS channels are present.
You must configure the line type as either E1MF or E1MFCRC for E1 lines; otherwise, this command
is invalid and does not process.
Examples The following example shows that line 3 is configured for CCS:
cnflnsig 3 2
Related Commands
line-num Line number you want to bring to the out-of-service state. In the range from 1 to
8.
line-signal-type Signaling type of the line. It can be one of the following values:
1 = Channel associated signaling (CAS)
2 = Common channel signaling (CCS)
3 = No signaling
Command Description
dspln Displays the characteristics of a VISM card line.