5-439
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dspt38nsetimeouts
dspt38nsetimeouts
To display all configured lines with a length of time in which to wait for a remote acknowledgment of
the offer to switch to fax transfer mode, use the dspt38nsetimeouts command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
dspt38nsetimeouts
Syntax Description This command has no arguments or keywords.
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the length of time in which to wait for a remote acknowledgment of
the offer to switch to fax transfer mode configured for all lines on the current VISM card is displayed:
dspt38nsetimeouts
Line_Number NSE Timeout (ms)
----------- ----------------
1 1000
2 1000
.
.
.
8 1000
Related Commands Command Description
cnfcodectmpl Assigns a codec template to an entire VISM card.
cnft38fxlco Configures the fax handling instructions for a specified line.
cnft38nsetimeout Configures a specified line with a length of time in which to wait for a remote
acknowledgment of the offer to switch to fax transfer mode.
cnft38params Configures the T.38 fax transfer parameters for a specified line.
dspcodectmpls Displays all entries in the codec template table.
dspt38fxlco Displays the fax handling instructions configured for a specified line.
dspt38fxlcos Displays the fax handling instructions for all lines on the current VISM card.
dspt38nsetimeout Displays a specified configured line with a length of time in which to wait for
a remote acknowledgment of the offer to switch to fax transfer mode.
dspt38params Displays the T.38 fax transfer parameters for a specified line.