5-168
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnflnis
cnflnis
To configure an out-of-service VISM card line to the in-service state, use the cnflnis command in the
VoIP switching/trunking operating mode.
cnflnis line-num
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines The configured in-service state is not maintained after a VISM card reboot. If you reboot a VISM card
previously configured to the in-service state with this command, you must use this command again to
configure the associated lines back to the in-service state , as need ed.
Examples The following example shows that line 2 is configured with the in-service state:
cnflnis 2
Related Commands
line-num Line number you want to bring to the in-service state. In the range from 1 to 8.
Command Description
cnflnoos Configures an in-service VISM card line to the out-of-service state.
dspgwstate Displays the current user-configured service state of the gateway.
dsplnstate Displays the service state of a VISM card line with respect to the xGCP protocol.