5-230
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfvismmode
cnfvismmode
To configure the initial operating mode for a VISM card, use the cnfvismmode command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
cnfvismmode oper-mode
Syntax Description
Command Modes VoIP switching/trunking, switched AAL1 SVC, switched AAL2 SVC, switched AAL2 PVC, AAL2
trunking, VoIP and switched ATM AAL1 SVC
Usage Guidelines You should delete all connections, ports, and resource partitions (if any) before using this command.
Existing configurations on a VISM card are cleared when you use this command on the card.
Examples The following example shows that the current VISM card is configured for the VoIP switching/trunking
operating mode:
cnfvismmode 1
Related Commands There are no related commands.
oper-mode VISM card operating mode. It can be one of the following values:
•1 = VoIP switching/VoIP trunking
•2 = ATM Adaptation Layer Type 2 (AAL2) trunking
•3 = Switched ATM AAL1 switched virtual circuit (SVC)
•7 = Switched ATM AAL2 SVC
•8 = Switched ATM AAL2 permanent virtual circuit (PVC)
•9 = VoIP and switched ATM AAL1 SVC