5-36
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
addrtpcon
addrtpcon
To add a static Real-Time Transport Protocol (RTP) VoIP trunking connection, use the addrtpcon
command in the VoIP switching/trunking operating mode.
addrtpcon conn-num endpt-num local-rtp-port remote-rtp-port remote-ip-addr codec-type
|vt-pkt-period bearer-prec bearer-tos conn-mode ecan-enable vad-enable vad-timer cas-trans
dtmf-trans idle-code-sup|
Syntax Description conn-num Connection identification number. It can be in the range from 1 to 248.
endpt-num Endpoint number. It can be a value from one of the following ranges:
•For template number 1:
–
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
•For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
•For template number 3:
–
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
•For template number 4:
–
For VISM-PR, from 1 to 144
local-rtp-port Static RTP local port number. It can be an even number in the range from 49648
to 50142.
Note The odd numbers within the local-rtp-port range are reserved for
Real-Time Conferencing Protocol (RTCP) ports.
remote-rtp-port Static RTP remote port number. It can be an even number in the range from
16384 to 50142.
Note The odd numbers within the remote-rtp-port range are reserved for
RTCP po rts.
remote-ip-addr IP address of the remote VISM card, in dotted decimal format
(nnn.nnn.nnn.nnn).