5-207
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfsesmaxwindow
cnfsesmaxwindow
To configure the maximum number of segments (window) that can be sent before receiving an
acknowledgment, use the cnfsesmaxwindow command in the VoIP switching/trunking operating mode.
cnfsesmaxwindow session-num window-size
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Use this command for a previously added PRI backhaul session.
Examples The following example shows that a maximum nu mbe r of 44 segments can be sent for session number 2
before receiving an acknowledgment:
cnfsesmaxwindow 2 44
Related Commands
session-num Identifying session number in the range from 1 to 64.
window-size Maximum number of segments that can be sent before receiving an
acknowledgment. It can be in the range from 1 to 64.
Command Description
cnfsesack Configures the timeout period before sending an acknowledgment, and th e
maximum number of acknowledgments that can be accumulated.
cnfsesmaxreset Configures the maximum number of resets that a VISM card performs before
a connection is reset.
cnfsesmaxseg Configures the maximum segment size, in octets, that can be received by a
VISM card after sending a synchronize message.
cnfsesnullsegtmout Configures the idle time before sending a null segment.
cnfsesoutofseq Configures the maximum number of out-of-sequence packets that ca n be
accumulated before sending an EACK packet.
cnfsesport Configures the port numbers of a previously added PRI backhaul session.
cnfsesretrans Configures the timeout period for unacknowledged packets and the number
of retransmissions.
cnfsesstatetmout Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
cnfsessyncatmps Configures the maximum number of call agent synchronization attempts.