5-209
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfsesoutofseq
cnfsesoutofseq
To configure the maximum number of out-of-sequence packets that can be accumulated before sending
an EACK packet, use the cnfsesoutofseq command in the VoIP switching/trunking operating mode.
cnfsesoutofseq session-num max-seq-pkts
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Use this command for a previously added PRI backhaul session.
Examples The following example shows that a maximum of 10 out-of-sequence packets c an be accumulated before
an EACK packet is transmitted for session number 2:
cnfsesoutofseq 2 10
Related Commands
session-num Identifying session number in the range from 1 to 64.
max-seq-pkts The maximum number of out-of-sequence packets that can be accumulated
before an EACK packet is transmitted. It can be in the range from 0 to 255.
Note If you specify 0, a DACK message is sent immediately upon
receiving an out-of-sequence packet.
Command Description
cnfsesack Configures the timeout period before sending an acknowledgment, and th e
maximum number of acknowledgments that can be accumulated.
cnfsesmaxreset Configures the maximum number of resets that a VISM card performs before
a connection is reset.
cnfsesmaxseg Configures the maximum segment size, in octets, that can be received by a
VISM card after sending a synchronize message.
cnfsesnullsegtmout Configures the idle time before sending a null segment.
cnfsesport Configures the port numbers of a previously added PRI backhaul session.
cnfsesretrans Configures the timeout period for unacknowledged packets and the number
of retransmissions.
cnfsesstatetmout Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
cnfsessyncatmps Configures the maximum number of call agent synchronization attempts.