5-440
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dspt38params
dspt38params
To display the T.38 fax transfer parameters for a specified line, use the dspt38params command in the
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
dspt38params line-num
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the T.38 fax transfer parameters for line 7 are displaye d:
dspt38params 7
line_number: 7
Max_Xmit_Rate: fx14400bps
Info_Field_Size: 48
Data_Pkt_size: 40 ms
LS_Data_Redundancy: 5
HS_Data_Redundancy: 2
TCF_Method: localTCF
Error_Correction: enabled
NSF_Override: enabled
NSF_Country_Code: 181
NSF_Vendor_Code: 18
Related Commands
line-num Line number of the DS1 line for which you want to di spla y T.38 fax transfer
parameters. It can be in the range from 1 to 8.
Command Description
cnfcodectmpl Assigns a codec template to an entire VISM card.
cnft38fxlco Configures the fax handling instructions for a specified line.
cnft38nsetimeout Configures a specified line with a length of time in which to wait for a remote
acknowledgment of the offer to switch to fax transfer mode.
cnft38params Configures the T.38 fax transfer parameters for a specified line.
dspcodectmpls Displays all entries in the codec template table.
dspt38fxlco Displays the fax handling instructions configured for a specified line.
dspt38fxlcos Displays the fax handling instructions for all lines on the current VISM card.
dspt38nsetimeout Displays a specified configured line with a length of time in which to wait for
a remote acknowledgment of the offer to switch to fax transfer mode.
dspt38nsetimeouts Displays all configured lines with a length of time in which to wait for a remote
acknowledgment of the offer to switch to fax transfer mode.