5-354
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dsplapdstat
dsplapdstat
To display configuration data about Link Access Protocol for ISDN D channel (LAPD) sta tisti cs
(counters) for a specific line and DS0, use the dsplapdstat command in the VoIP switching/trunking
operating mode.
dsplapdstat line-num ds0-num
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the LAPD statistic configuration data for line n umber 1, DS0 number
1 are displayed:
dsplapdstat 1 1
vismLapdStatsIndex: 1
vismLapdRxInfoFrames: 0
vismLapdTxInfoFrames: 0
vismLapdRxReadyFrames: 0
vismLapdTxReadyFrames: 0
vismLapdRxNotReadyFrames: 0
vismLapdTxNotReadyFrames: 0
vismLapdRxSABMFrames: 0
vismLapdTxSABMFrames: 0
vismLapdRxDisconFrames: 0
vismLapdTxDisconFrames: 0
vismLapdRxUAFrames: 0
vismLapdTxUAFrames: 0
vismLapdRxDiscModeFrames: 0
vismLapdTxDiscModeFrames: 0
vismLapdRxFrmRejectFrames: 0
vismLapdTxFrmRejectFrames: 0
vismLapdRxExchIdFrames: 0
vismLapdTxExchIdFrames: 0
vismLapdRxUnumInfoFrames: 0
vismLapdTxUnumInfoFrames: 0
vismLapdRxRejectFrames: 0
vismLapdTxRejectFrames: 0
vismLapdRxInvalidFrames: 0
line-num Line number of the channel for which you want to display the LAPD statistics. I t can
be in the range from 1 to 8.
ds0-num DS0 number of the channel for which you want to display the LAPD statistics. It can
be a value from one of the following ranges:
•1 to 24 for T1 lines
•1 to 31 for E1 lines