5-363
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dsplncids
dsplncids
To display the channel identification (CID), endpoint, and AAL2 configuration data for a VISM card
line, use the dsplncids command in the switched AAL2 PVC and AAL2 trunking operating modes.
dsplncids line-num
Syntax Description
Command Modes Switched AAL2 PVC and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the CID, endpoint, and AAL 2 c on figurati on da ta for li ne 2 a re
displayed:
dsplncids 2
lcn CID Endpt Cid Type3 VAD Prof Prof Codec Cas DTMF
Num Num Num Status Redun VAD Timer Type Num Type Tran Tran Ecan
--- --- ----- ------ ----- --- ----- ------ ---- --------- ---- ---- ----
33 10 2 active ena ena 250 ITU 1 G.711u ena ena ena
Note If you configure the codec type as clear for the line number identified by the line-num argument, the
Type3 Redun, Cas Tran, DTMF Tran, and Ecan values are not applicable.
Related Commands
line-num Line number for which you want to display the CID, endpoint, and AAL2
configuration data. It can be in the range from 1 to 8.
Command Description
addcid Adds an AAL2 CID on a VISM card.