4-50
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter4 Configuring VISM Features
Configuring VISM Features
Complete the following steps to configure ISDN PRI backhaul:
Step 1 Type the addsesset command, set-num and fault-tol-enable argument values, and press Enter to create
a session set. Specify the arguments with the following values:
•set-num: In the range from 1 to 16
•fault-tol-enable:
–
1 = Yes
–
2 = No
Step 2 Type the addsesgrp command, group-num, set-num, and mgc-name argument values, and press Enter
to create a session group for a session set and a call agent. Specify the arguments with the following
values:
•group-num: In the range from 1 to 16
•set-num: In the range from 1 to 8
•mgc-name: A text string of up to 64 alphanumeric characters
Step 3 Type the addses command, session-num, group-num, priority, local-port-num, and remote-port-num
argument values, and press Enter to create an ISDN PRI backhaul RUDP session within a specified
group. Specify the arguments from the following values:
•session-num: In the range from 1 to 64
•group-num: In the range from 1 to 16
•priority: In the range from 1 (highest) to 4 (lowest)
•local-port-num: The VISM port number you want to use for the session
•remote-p ort-num : The call agent (remote) port number you want to use for the sessi on
Note The following session configuration commands apply to a single session which is identified by the
first argument, the session-num.
Step 4 Type the cnfsesack command, session-num, ack-timeout, and max-acks argument values, and press
Enter to change the timeout period for sending out an ac kn owledgme nt a nd the m axi mum n um ber o f
acknowledgments that can accumulated before sending them. Specify the arguments with the following
values:
•session-num: In the range from 1 to 64
•ack-timeout (defined in milliseconds): In the range from 100 to 65535
•max-acks: In the range from 0 to 255
Step 5 Type the cnfsesmaxreset command, session-num and max-resets argument values, and press Enter to
configure the maximum number of resets that VISM performs before a conne ction i s r eset. Spe c ify the
arguments with the following values:
•session-num: Type the value entered for the session-num argument in Step 4.
•max-resets: In the range from 0 to 255