5-66
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfaal2subcellmuxing
cnfaal2subcellmuxing
To enable or disable AAL2 subcell multiplexing, use the cnfaal2subcellmuxing command in the AAL2
trunking operating mode.
cnfaal2subcellmuxing mux-enable
Syntax Description
Command Modes AAL2 trunking
Usage Guidelines When you enable multiplexing, multiple CPS packets are multiplexed onto a single AAL2 connection
without partial fill (unless there is a timeout). When you disable multiplexing, each CPS packet fills one
or two cells (with padding).
Note The field length for each CPS packet can be up to 64 bytes.
When the multiplexing type is changed if CIDs are present, the card is reset and existing
CIDs/connections are restored with the multiplexing type.
Examples The following example shows that subcell multiplexing is disabled:
cnfaal2subcellmuxing 2
Related Commands There are no related commands.
mux-enable Enables or disables AAL2 subcell multiplexing. It can be one of the following values:
•1 = On
•2 = Off