5-58
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
clrrtpcnt
clrrtpcnt
To clear the Real-Time Transport Protocol (RTP) counters (statistics) for a specific static RTP
connection, as shown by the dsprtpcnt command, use the clrrtpcnt command in the VoIP
switching/trunking operating mode.
clrrtpcnt conn-num
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the RTP counters for static RTP connection number 49 are cleared:
clrrtpcnt 49
Related Commands
conn-num Connection identification number. It can be in the range from 1 to 248.
Command Description
addlapdtrunk Adds an LAPD trunk to a specific VISM card line.
addrtpcon Adds a static RTP VoIP trunking connection.
addrudptrunk Adds an ISDN PRI backhaul RUDP session for an LAPD trunk connection.
cnflapdtrunkpvc Assigns the PVC trunk type that carries LAPD m essages for the current VISM
card.
cnflntrunkcond Enables or disables line conditioning on a VISM card line if a network alar m is
encountered.
cnfrtpcon Modifies an existing static RTP VoIP trunking connection.
cnfrudptrunkrmtip Modifies the remote IP address of VISM used in the ISDN PRI backhaul RUDP
trunk for a specified session.
dellapdtrunk Deletes an LAPD configured line.
delrtpcon Deletes a static RTP VoIP trunking connection.
delrudptrunk Deletes an ISDN PRI backhaul RUDP session that is associated with an LAPD.
dsplapd Displays data about an LAPD.
dsplapdtrunkpvc Displays the assigned PVC trunk type that carries LAPD trunk messages for the
current VISM card.
dsplapdtrunks Displays the configuration data of all LAPD trunks.
dsprtpcnt Displays the bearer counters (statistics) for a specific RTP VoIP trunking
connection.
dsprtpcon Displays the configuration data of a specific static RTP VoIP trunking
connection.
dsprtpconnstat Displays the RTP connection statistics for a specified endpoint.