5-429
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dspsrcpcnt
dspsrcpcnt
To display the Simple Resource Control Protocol (SRCP) message counters (statistics) for a specified
call agent, use the dspsrcpcnt command in the VoIP switching/trunking operating mode.
dspsrcpcnt ca-ip-address
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the SRCP message counters (statistics) of IP address 209.165.200.22 4
are displayed:
dspsrcpcnt 209.165.200.224
Ip Name Discarded Augw/Fail Auln/Fail Ntfy/Fail Rqnt/Fail
--------- -------- --------- --------- --------- --------- ---------
2.2.2.2 mgc1 0 0/0 0/0 0/0 0/0
Related Commands
ca-ip-address IP address of the call agent for which you want to display SRCP statistics. It can
be in dotted decimal format (nnn.nnn.nnn.nnn).
Command Description
dspsrcpcnts Displays SRCP message counters (statistics) for all known call agents.
dspsrcppeer Displays the peer configuration data for a specified SRCP peer (call agent).
dspsrcppeers Displays the peer configuration data for all known SRCP peers (call agents).
dspsrcpport Displays the local UDP port number used by the SRCP on VISM.
dspsrcpretry Displays the card level SRCP retransmission parameters—maximum number
of retransmission attempts, minimum timeout, and maximum timeout.