5-437
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dspt38fxlcos
dspt38fxlcos
To display the fax handling instructions for all lines on the current VISM card, use the dspt38fxlcos
command in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
dspt38fxlcos
Syntax Description This command has no arguments or keywords.
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the fax handling instructions for all lines on the current VISM card
are displayed:
dspt38fxlcos
Line_Number Fx LCO
----------- ------
1 Gateway controlled preferred then pass-through
2 Gateway controlled preferred then pass-through
.
.
.
8 Gateway controlled preferred then pass-through
Related Commands Command Description
cnfcodectmpl Assigns a codec template to an entire VISM card.
cnft38fxlco Configures the fax handling instructions for a specified line.
cnft38nsetimeout Configures a specified line with a length of time in which to wait for a remote
acknowledgment of the offer to switch to fax transfer mode.
cnft38params Configures the T.38 fax transfer parameters for a specified line.
dspcodectmpls Displays all entries in the codec template table.
dspt38fxlco Displays the fax handling instructions configured for a specified line.
dspt38nsetimeout Displays a specified configured line with a length of time in which to wait for
a remote acknowledgment of the offer to switch to fax transfer mode.
dspt38nsetimeouts Displays all configured lines with a length of time in which to wait for a remote
acknowledgment of the offer to switch to fax transfer mode.
dspt38params Displays the T.38 fax transfer parameters for a specified line.