5-486
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
pinglndsp
pinglndsp
To display the digital signal processor (DSP) configuration data and status for all endpoints on a
specified line, use the pinglndsp command in the VoIP switching/trunking, switched AAL2 PVC, and
AAL2 trunking operating modes.
pinglndsp line-num
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the DSP configuration data and status for the VISM card line 1 is
displayed:
pinglndsp 1
Related Commands
line-num Line number for the DSPs you want to display configuration data and st atus. I t ca n
be a value in the range from 1 to 8.
Command Description
dsplndsp Displays the DSP information for a specified VISM card line.