5-422
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dspses
dspses
To display the configuration data of a Primary Rate Interface (PRI) backhaul session, use the dspses
command in the VoIP switching/trunking and switched AAL2 PVC operating mode.
dspses session-num
Syntax Description
Command Modes VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the configuration data of PRI backhaul session numbe r 1 is displayed:
dspses 1
vismRudpSessionNum: 1
vismRudpSessionGrpNum: 1
vismRudpSessionPriority: 1
vismRudpSessionState: Oos
vismRudpSessionCurrSession: 0
vismRudpSessionLocalIp: xxx.xx.xx.xxx
vismRudpSessionLocalPort: 1124
vismRudpSessionRmtIp: xxx.xx.xx.xx
vismRudpSessionRmtPort: 1124
vismRudpSessionMaxWindow: 32
vismRudpSessionSyncAttempts: 5
vismRudpSessionMaxSegSize: 384
vismRudpSessionMaxAutoReset: 5
vismRudpSessionRetransTmout: 600
vismRudpSessionMaxRetrans: 3
vismRudpSessionMaxCumAck: 3
vismRudpSessionAckTmout: 300
vismRudpSessionMaxOutOfSeq: 4
vismRudpSessionNullSegTmout: 2000
vismRudpSessionTransStateTmout: 2000
Related Commands
session-num Identifying session number in the range from 1 to 64.
Command Description
addses Adds a PRI backhaul session between a VISM card and a call agent.
delses Deletes a PRI backhaul session.
dspsess Displays the configuration data of all PRI backhaul sessions.