xiv
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Preface
Related Documentation
•Chapter5, “CLI Commands,” describes the syntax and semantics of each VISM command line
interface command.
•Chapter 6, “Troubleshooting Tips,” describes VISM troubleshooting tools and techniques.
•Appendix A, “VISM and VISM-PR Card Clocking Options,” describes clocking configuration for
both the VISM card and MGX 8000 Series platform PXM cards.
•AppendixB, “VISM and VISM-PR—3.0 Specifications,” describes the specifications of VISM
Release 3.0.
Related Documentation
The following sections describe documentation you may need to reference as you use the VISM product.

Cisco MGX 8850 (PXM45) Multiservice Switch Release 3

The documentation for the installation and operation of the MGX 8850 Multiservice Switch for Release
3 is listed in Table 1 .
Table1 Cisco MGX 8850 (PXM45) Multiservice Switch Release 3 Documentation
Title Description
Cisco MGX 8850 Hardware Installation Guide, Release 3
(PXM45/B and PXM1E) Describes how to install the MGX 8850 multiservice switch.
This guide explains what the switch does and covers site
preparation, grounding, safety, card installation, and cabling.
The MGX 8850 switch uses either a PXM45 or a PXM1E
controller card and provides support for both broadband and
narrow band service modules.
Cisco MGX 8850, MGX 8950, and MGX 8830 Command
Reference (PXM45/B and PXM1E), Release 3 Describes how to use the PXM and AXSM commands that are
available for the MGX 8850, MGX 8950, and MGX 8830
switches.
Cisco Frame Relay Software Configuration Guide and
Command Reference for the MGX 8850 FRSM12 Card,
Release 3
Describes how to use the high-speed Frame Relay (FRSM12)
commands that are available for the MGX 8850 switch.
Cisco MGX 8850 (PXM45) and MGX 8950 Software
Configuration Guide, Release 3 Describes how to configure MGX 8850 and MGX 8950 switches
with PXM45 controller cards to operate as ATM edge or core
switches. This guide also provides some operation and
maintenance procedures.
Cisco MGX and SES PNNI Network Planning Guide for
MGX Release 3 and SES Release 3 Provides guidelines for planning a PNNI network that uses the
MGX 8850 and the MGX 8950 switches and the BPX 8600
switches. When connected to a PNNI network, each BPX 8600
series switch requires a SES for PNNI route processing.
Cisco MGX Route Processor Module (RPM-XF)
Installation and Configuration Guide, Release 3 Describes how to install and configure the MGX Route Processor
Module (RPM-XF) in the MGX 8850 Release 3 switch. Also
provides site preparation, troubleshooting, maintenance, cable
and connector specifications, and basic Cisco IOS co nfiguration
information.