5-362
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
dspln
dspln
To display the configuration data of a VISM card line, use the dspln command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
dspln line-num
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the configuration data for the current VISM card’s line number 1 is
displayed:
dspln 1
LineNum: 1
LineConnectorType: RJ-48
LineEnable: Enabled
LineType: dsx1ESF
LineCoding: dsx1B8ZS
LineLength: 0-131 ft
LineXmtClockSource: LocalTiming
LineLoopbackCommand: NoLoop
LineSendCode: NoCode
LineUsedTimeslotsBitMap: 0x3ff
LineLoopbackCodeDetection: codeDetectDisabled
LineSignalingType: CAS
LineCcsChannels: 0x0
LineTrunkConditioning: disable
LineNumOfValidEntries: 8
Note The LineCcsChannels data applies only to the AAL2 trunking operating mode.
Related Commands
line-num Line number for which you want to display the configuration da ta. I t can be i n the
range from 1 to 8.
Command Description
addln Adds a T1 or E1 line to a VISM card.
cnfln Configures characteristics for a VISM card line.
delln Deletes a T1 or E1 line from a VISM card.