5-68
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfaal2transparams
cnfaal2transparams
To configure the transportation of DTMF and CAS bits to another endpoint and enable or disable type 3
packet triple redundancy feature, use the cnfaal2transparams command in the switched AAL2 PVC
operating mode.
cnfaal2transparams dtmf-trans cas-bits-trans type-3-red
Syntax Description
Command Modes Switched AAL2 PVC
Usage Guidelines Follow standard CLI procedures when using this command.
Examples The following example shows that DTMF tone transportation, CAS bits transportation, and triple
redundancy protection are enabled:
cnfaal2transparams 1 1 1
Related Commands There are no related commands.
dtmf-trans Enables or disables DTMF tone transport as AAL2 type 3 packets. It can be one of
the following values:
1 = On. DTMF relay using RFC 2833.
2 = Off. DTMF pass through.
Note The dtmf-trans argument value must be set to 1 (on) if you are using codecs
other than G.711 and G.726.
cas-bits-trans Enables or disables CAS bits transportation. It can be one of the following values:
•1 = On
•2 = Off
type-3-red Enables or disables triple redundancy protection for type 3 packets. It can be one
of the following values:
•1 = On
•2 = Off