5-133
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfconvcci
cnfconvcci
To associate a virtual circuit connection identifier (VCCI) and a remote address with an LCN, use the
cnfconvcci in the switched AAL2 PVC operating mode.
cnfconvcci lcn vcci-num addr-type |fe-addr|
Syntax Description
Command Modes Switched AAL2 PVC
Usage Guidelines The VCCI number does not need to be unique for the not applicable (1) address type, and the far end
address is not used.
The combination of VCCI number and far end address mu st be uniqu e for t he fol lowing a ddress t ypes:
•NSAP (2)
•E.164 (3)
•Gateway ID (4)
The VCCI number must be unique for the unspecified (5) address t ype, even though the far end address
is not used.
Examples The following example shows that LCN 131 is not associated with a VCCI or far end address:
cnfconvcci 131 1
Related Commands
lcn Logical channel number of the connection; in the ra nge fr om 13 1 to 51 0.
vcci-num VCCI number. It can be in the range from 0 to 65535.
addr-type Address type of the VCCI. It can be one of the following values:
•1 = Not applicable
Note This address type disassociates a VCCI, far end address type, and far end
address from an LCN.
•2 = NSAP (20-byte hexadecimal address)
•3 = E.164 (1- to 15-byte decimal address)
•4 = Gateway ID (1- to 64-byte ASCII character address)
•5 = Unspecified
fe-addr (Optional) Far end IP address. This argument is optional if the addr-type value = 1 or
5. This argument is mandatory if the addr-type value = 2, 3, or 4.
Command Description
dspcon Displays the parameters for a specified LCN.