5-234
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfxgcpbt
cnfxgcpbt
To configure a default bearer type—if one is not specified by the call agent by the xGCP local connection
options—for the current VISM card, use the cnfxgcpbt command in the VoIP switching/trunking,
switched AAL2 PVC, and AAL2 trunking operating modes.
cnfxgcpbt network-type vc-type aal-conn-type
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines If the default bearer types (network, VC, or connection) are specified as part of the local connection
options, those types take precedence over the types specified in this comm a nd.
Examples The following example shows that the current VISM card is configured for the IP network type and for
PVC:
cnfxgcpbt 1 1 3
Related Commands
network-type Network type. It can be one of the following values:
•1 = IP
•2 = ATM
vc-type Virtual circuit type. It can be one of the following values:
•1 = Permanent virtual circuit (PVC)
•2 = Switched virtual circuit (SVC)
aal-conn-type Connection type. It can be one of the following values:
•1 = ATM Adaptation Layer Type 1 (AAL1)
•2 = ATM Adaptation Layer Type 2 (AAL2)
•3 = Not applicable
Note You must select 3 (not applicable) if you selected a network-type
argument value of 1 (IP).
Command Description
dspxgcpbt Displays the default network, VC, and connection types configured for t h e
current VISM card.