5-140
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter5 CLI Commands
cnfds0gain
cnfds0gain
To configure the adjustable gain for a specified DS0, use the cnfds0gain command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
cnfds0gain line-num ds0-num input-gain output-atten
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking.
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the VISM card line number 2, DS0 number 13, is configured with a
–10-dB input gain value and a 60-dB output attenuation value:
cnfds0gain 2 13 -10 60
Related Commands
line-num Line number of the DS0 that you want to configure the adjustable gain. In the range
from 1 to 8.
ds0-num DS0 number on which to configure adjustable gain. It can be a value from one of
the following ranges:
•1 to 24 for T1 lines
•1 to 31 for E1 lines
input-gain Input gain (defined in decibels). It can be in the ran ge f rom – 60 to 140 i n
increments of 10.
output-atten Output attenuation (defined in decibels). It can be in the range from 0 to 140 in
increments of 10.
Command Description
cnfgain Configures the adjustable gain for a VISM card.
cnflngain Configures the adjustable gain for all DS0s on a specified VISM card line.
dspds0gain Displays the adjustable gain values for a specified DS0.
dspgain Displays the adjustable gain for a specified VISM card.
dsplngain Displays the adjustable gain for a specified VISM card line.