Cisco Systems (VISM) Connecting to Cisco MGX 8000 Series Platforms

4-2

Cisco VISM Installation and Configuration Guide

Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004

Chapter4 Configuring VISM Features

Connecting to Cisco MGX 8000 Series Platforms

Use the information in Table 4 -1 to determine the log file attributes, VISM card state requirements for

command use, and personnel privileges for all VISM co mma nd s.

Note For a complete description of the CLI commands in this chapter, see Chapter5, “CLI Commands.”

Connecting to Cisco MGX 8000 Series Platforms

The VISM card operates in the following MGX 8000 Series platforms:

•Cisco MGX 8850 Release 1, wide area switch

•Cisco MGX 8250, edge concentrator

•Cisco MGX 8230, edge concentrator

Each platform contains a Processor Module (PXM) back card (see Figure4-1). Connect your CLI

command administration terminal or workstation to the PXM b ack ca rd’s control port —l ocal ly or

remotely through a modem.

Note The MGX 8000 Series platform PXM back card contains all co nnections for managing VISM cards.

The VISM card itself has no physical management ports.

Table4-1 VISM Command Attributes—Log File, Card State, and Privilege Level

Commands that

begin with... ...write to the

log file? ...are usable in

what state? ...can be used by personnel

with what privilege level?

1. The text shown represents the complete CLI command name.

No All All

add Yes Active 1

cc1Yes Al l Al l

chkflash1Yes Act ive 1

clr No Active 1 to 5

cnf Yes Active 1

del Yes Active 1

dsp No Active All

Help1No All All

pinglndsp1No Active All

tst No Active All

version1No Active All