HP Web Jetadmin Software manual Fax Send Resolution, Fax Send Setup, Fax Send Settings

Fax Send - Resolution

This option lets you sets the default resolution that will be used when sending faxes. The available selections are Standard, Fine, Superfine, and Photo. This lets you control the quality of the sent faxes when the default setting is used.

To configure this option, select the desired resolution.

Fax Send - Setup

Use this option to specify the send settings for faxes. You can specify the modem and ringer volumes, the dial and redial settings, and whether the fax device should use JBIG compression or Error Correction Mode (ECM).

Following are steps to configure this option:

1.Select the fax dial volume from the Fax dial volume drop-down list.

2.To enable Error Correction Mode (ECM), select Enabled from the Error correction mode drop-down list. ECM should normally be enabled, except in extreme circumstances where line conditions are too poor to support ECM faxes.

3.To enable JBIG compression, select Enabled from the JBIG compression drop-down list. JBIG compression is a protocol that allows for faster fax sending between two JBIG compliant fax devices. It is possible that older fax machines may fail to connect when JBIG is enabled. For such a scenario, use the JBIG disable option.

4.Select Tone or Pulse from the Dialing mode drop-down list.

5.Select the number of retry attempts when the receiving line is busy, from the Redial on busy drop- down list.

6.Select the number of retry attempts when the receiving line fails to answer from the Redial on no answer drop-down list.

7.To have the fax wait for a dial tone before dialing for an outbound fax document, select Enabled from the Detect dial tone drop-down list.

8.To specify a dialing prefix, type the value in the Dialing prefix text box.

9.To print the billing code report, select the Print billing code list checkbox.

Fax Send Settings

Use this option to specify the settings for sending faxes. You can specify the fax send method, scan settings, notification settings, internal modem settings, LAN fax settings, and Internet fax settings.

Following are steps to configure this option:

1.To enable sending faxes, select the Enable fax send checkbox.

2.Select the method the device uses to send faxes from the Fax send method drop-down list.

3.In the Common Job Settings—Scan settings section, specify the following settings for the original documents and scanned output:

●Default resolution: Select the default resolution used when the original documents are scanned.

●Original size: Select the default size of the original documents.

●Custom dimension units: If you select Custom from the Original size drop-down list, select the default unit of measurement used for the original documents.

390 Chapter 6 Device Configuration Options ENWW