Sleep Timer Settings

Use this option to configure the Sleep Mode/Auto Off feature on the device. When this feature is enabled, the device automatically enters Sleep mode or Auto Off mode after a specified period of inactivity and then wakes up when the specified events occur.

CAUTION: Configuring the Sleep Timer Settings configuration option for some devices might cause those devices to enter a deep sleep mode. USB-based solutions that are connected to these devices might be disabled. HP Web Jetadmin does not display a message or provide any indication that the USB-based solutions will be disabled.

To enable the Sleep Mode/Auto Off feature, perform the following steps:

1.Select the Enable Sleep Mode/Auto Off Timer checkbox.

2.Enter the number of minutes the device waits with no activity before entering Sleep mode in the Sleep Mode/Auto off after field. Valid values are 1 through 120.

3.To specify which events wake up the device, select one of the following options:

●All events: The device wakes up when any event occurs.

●Network port: The device wakes up only when a network port event occurs.

●Power button only: The device wakes up only when the power button on the device is pressed. To disable the Sleep Mode/Auto Off feature, clear the Enable Sleep Mode/Auto Off Timer checkbox.

Stacker Staple Setting

Use this option to specify the number of staples put on each print job. The stacker staple setting specified in HP Web Jetadmin overrides the setting specified through the printer control panel.

To configure this option, select No Stapling or One Staple.

Stand by Fuser Mode

Use this option to set the temperature for a Fuser Mode when it is in standby mode. Turning this off means using less energy but warm up time for a print job will take longer.

To set this option, select the temperature from the drop-down box.

Stapler Offset Mode

If an HP 3-bin Stapler/Stacker accessory is installed on the device, use this option to specify whether each print job is offset in the output bin. Offsetting the print jobs makes it easier to separate multiple print jobs.

To disable this option, select the Off option. To enable this option, select the On option.

Staples Out Override

Use this option to specify the default action that the printer takes when the output bin is full or when the stapler runs out of staples.

To configure this option, select Stop or Continue.

HP Web Jetadmin Software manual Sleep Timer Settings, Stacker Staple Setting, Stand by Fuser Mode

Models: Web Jetadmin Software