DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects

3-470DID-DS1 (DS1 DID Trunk)

3
Port Audit and Update Test (#36)
This test sends port level translation d ata from the switch processor to the DS1 Interface circuit p ack to assure that the trunk’s translation is c orrect. Translation updates includ e the following data: trunk type (in/out), dial type, timing parameters, and signaling bits enabled. The port audit operation verifies the consistency of the current state of the trunk as kept in the DS1 Interface circ uit pack and in the switc h software.
Table 3-199. TEST #36 Port Audit and Update Test
Error
Code
Test
Result Description/ Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000 ABORT The port may be busy with a valid call. Issue the display port PCSSpp
command to determine the trunk group/member number of the port. Use
the status trunk command to determine the service state of the port. If the
service state indicates that the port is in use, then the port is unavailable
for certain tests. You must wait until the port is idle before retesting.
1. If the port status is active but the port is not in use (no calls), chec k the
error log for error type 1025 (see the Error Log table for a description
of this error and required actions). The port may be locked up.
2. If the port status is idle, retry the command at 1-minute intervals a
maximum of 5 times.
1006 ABORT The test was aborted because the trunk is out of service.
1. Use the status trunk command to verify that the trunk is out of
service.
2. If the trunk is out of service, determine why.
3. If it is OK to put the trunk back in service, issue the release trunk
command to put the trunk back in service, and then retry the test.
2000 ABORT Response to the test was not received within the allowable time period.
2100 ABORT Could not allocate resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
FAIL Test failed due to Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page