Lucent Technologies 555-233-119 3-43ANL-24-L (24-Port Analog Line)

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Objects
3-43ANL-24-L (24-Port Analog Line)
3
Table 3-18. TEST #35 Battery Feed Test
Error
Code
Test
Result Description/Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call. This result is also reported for the system’s
Music-On-Hold port when it is off-hook, which it usually is.
1004 ABORT The port was seized by a valid call during the test. The test has been
aborted.
1. Use the display port PCSSpp command to determine the station
extension.
2. Use the status station command to determine the service state of the
port.
3. If the port is in use, wait until the port is idle and retry the command at
1-minute intervals a maximum of 5 times.
1005 ABORT The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equip ment other than a voice
terminal (for example, the modem pool member or Music On Hold).
1018 ABORT The test has been disabled via administration. The default for the Test field
on the station form is y. Determine why this field has been set to n on this
station (this may be due to the ringing application test 48, that can be
customer or terminal disturbing).
1. To enable the test for a particular station being tested, enter change
station extension and set the Test? field on the station from n to y.
1392 ABORT This port is currently a TTI port and the test will not execute on it.
1. Verify that the port is a TTI port using either the display port command
(the display shows that the port is a TTI port) or the list config
command (the display shows a t for the port).
2. If the port is
not a TTI port, escalate the problem. If both commands
indicate that the port is a TTI port, the abort is correct for the test, and
no action is necessary.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page