DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects

3-800MEDPRO (Media Processor MAPD Circuit Pack)

3
SAKI Sanity Test (#53)
This is a destructive test.This test is only run as a part of a reset board procedure. For the Media Processor, it is necessary to use the change ip-interfaces form to d isable the Media Processor IP interface before p erforming this reset board procedure. Other common circuit p acks can be reset with the reset boa rd UUCSS command which also exec utes this test.A reset of this circuit pac k will take about 3 1/2 minutes.
Table 3-344. TEST #53 SAKI Sanity Test
Error
Code
Test
Result Description/ Recommendation
None ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1015 ABORT Port is not out-of-service.
1. Busy out the circuit pack.
2. Execute command again.
2100 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2803 ABORT It is necessary to reset the board.
1. Use the chang e ip-interfac es form to disable th e Media Processor IP
interface.
2. Execute the command again.
1 FAIL The circuit pack failed to reset.
2 FAIL The circuit pack failed to restart.
1. Execute command again.
2. If the problem persists, replace the circ uit pack.
PASS The circuit pack initializes correctly.
1. Run the short test sequence.
Any NO
BOARD This is normal if the test is being done when (a) the board is not physically in
the system or (b) the system is booting up. Otherwise, there is some
inconsistency between the physical configuration and the data kept in the
system.
1. Verify that the board is physically in the system.
2. Verify that the system is not in a stage of booting up.
3. Retry the command at 1-minute intervals for a maximum of 5 times.
Continued on next page