DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-969PROCR (RISC Processor Circuit Pack TN798)
3
Notes:
a. The BOOTPROM Checksum Test (#80) failed. Refer to the FAIL condition
of this test for further action.
b. A parity error was detected in the processor’s data c ache or instruction
cache. Aux Data indic ates the difference in the number o f parity errors
since the last report.
c. The Processor Bus Time-out Test (#82) failed. Refer to the FAIL condition
of this test for further action.
d. Aux Data of 100 is an LMM initialization failure.
e. The Processor Sanity Timer Test failed during a reset level 4 or 5
initialization. reset system 4 at the customers con venience and if the alarm
occurs again, rep lace the Processor circuit pac k. The system runs with
this failure, but it is not protected if the system software has a sanity
problem. The test processor a long clear command c lears this alarm, but
the sanity timer is only tested during initialization so the alarm occ urs
again and the system is not p rotected against insane software.
1025(b) Any Processor Cache Audit
(#896) MINOR ON test processor a r 2
1281 Any Processor Cache
Test(#895) MAJOR ON test processor a r 1
1793(c) Processor Bus
Time-out Exception
Test (#82)
MAJOR ON test processor a r 2
2049(d)(e
)Any Processor Sanity Timer
Test MINOR ON test processor a l c
1. The MTP Reset Test (#101) logs you off. The MTP Dual Port Ram Test (#104) can also log you off.
2. Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommend ed procedures.
Table 3-423. RISC Processor Circuit Pack Error Log Entries — Continued
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value1
Continued on next page