DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-1111TIE-TRK (Tie Trunk)
3
f. This is a software audit error that does not indic ate any hardware
malfunction. Run the Short Test Sequence and investigate associated
errors (if any).
g. This indicates that the trunk in q uestion has been busied-out b y
maintenance personnel.
h. This indicates that the circuit pack has been removed or has been insane
for more than 11 minutes. To clear the error, reinsert or replace the circ uit
pack.
i. The rotary dial rate was too slow (less than eight pu lses per second.)
Check the far-end PBX to ensure a translation match at b oth ends.
j. The rotary dial rate was too fast (more than 12 pulses per second .) Check
the far-end PBX to ensure a translation match at both end s.
k. The time between digits was too short (less than 300ms). Check the
far-end PBX to ensure a translation match at both end s.
l. This indicates that the trunk is still seized wi th an incoming call. The
far-end PBX is not releasing the trunk after the call is d ropped. A Minor
alarm is generated every four m inutes until the far-end PBX releases the
trunk. Check the far-end PBX for problems.
Once the trunk is released from the c all, the severity of this problem is
decreased. If Error Type 1025 does not app ear again, this means that the
problem has been c orrected. Verify that Error Type 1025 does not
reappear in the Error Log.
m. Reorder message. Trunk could not be seized. This error causes the Tie
Trunk Seizure Test (#73) to run, and it is considered a problem only if the
Seizure Test fails (in which case Error Type 1793 also shows up). In this
case, the trunk may be plac ed in the "Ready-for-Service" state (shown as
"disconnected" by the status c ommand), which allows only inc oming calls.
Run the Tie Trunk Seizure Test and follow its outlined procedures.
n. Test calls made by the Automatic Transmission Measurement System
(ATMS) returned measurements that were outside the acceptab le limits.
Use the list testcall detail command to examine specific transmission
parameters that are out of spec, and investigate the trunk for that kind of
noise. If the noise is accep table, the limits administered on the "change
trunk" screen should be chang ed.