DEFINITY ECS Release 8.2 Maintenance for R8.2csi

555-233-119 Issue 1
April 2000

Maintenance Objects

3-899PKT-INT (Packet Interface)
3
Error Log Entries and Test to Clear Values
1 S is the instance of the Packet Interface (1 or 2).
2 Indicates that an alarm was raised but an associated error was not entered into the hardware er ro r l og
due to a momentary overload condition caused by a burst of hardware or software error reports. Run the
long test sequence. Refer to the appropriate test descriptions for any failures and follow the
recommended procedures.
3 The I/O Processor or Packet Interface instance can only be reset if it has been taken out of service by
background maintenance software.
4 The error type or test applies only to Packet Interface 2, i.e., the Packet Interface instance that uses the
Packet Bus.

Table 3-387. Packet Interface Error Log Entries

Error

Type

Aux

Data Associated Test Alarm Level

On/Off

Board Test to Clear Value1
020 Any Any ON test packet-interface 1AS r 2
1 (a) Any None MAJOR ON reset io-processor3
10 (b) 0 None
23 (c) 0 None MAJOR OFF
50 (d) 0 None
100 (e) 0 None
217 (g) 0 None WARNING OFF
257 (f) Any None MAJOR ON reset io-processor3
267 (g) 0 None WARNING OFF
513 (h) Any None MAJOR ON reset io-processor 3
7694 (i) Any Mtce Looparound Test
(#886)4MAJOR ON test packet-interface 1AS r 3
1025 (j) Any Private Looparound
Test (#885) MAJOR ON reset packet-interface 1A S 3
1026 (j) Any None MAJOR ON reset packet-interface 1AS3
12814 (k) Any None MAJOR ON reset packet-interface 1AS3
1537 (l) Any Memory Checksum
Test (#884) MINOR ON test packet-interface 1AS r 2
1793 (m) Any Memory Checksum
Test (#884) MINOR ON test packet-interface 1AS r 2
20494 {n} Any None WARNING ON test packet-interface 1AS r 25
23054(o) Any None test packet-interface 1AS r 2
3074 (p)
3073
3072
Any Mtce Looparound Test
(#886)4WARNING OFF test packet-interface 1AS s r 2
3329 (q) Any None WARNING OFF reset packet-interface 1AS3
35854 (r) Any None WARNING OFF reset packet-interface 1AS3
38414(s) Any None MAJOR OFF reset packet-interface 1AS3