Lucent Technologies 555-233-119 Status bri-port interpretation

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Commands
2-230status bri-port
2
Status bri-port interpretation
Table 2-3 provides information on the status bri-port form.
Endpt SPID This field displays the SPID administered on the voice/data
endpoint associated with the link. Note that this information is
displayed only if the l ink is in either the “established ”
(point-to-point config uration) or the “13-established ” (multipoint
configuration) layer 2 state. Otherwise th is field is blank.
Service SPID Indicates if the link is associated with the Service SPID. If the link
is associated with Service Spud s, the field contains a “y es” and
the endpoint extension field is blank; otherwise, this field is bl ank.
Service SPID checks building wiring between the switch and the
BRI endpoint.
Table 2-3. Status BRI-Port Command Interpretation
Endpoint
Type s
TEI
Range Layer 2 State
Voic e
Extension
Service
SPID Description / Recommendation
ASAI, BRI 0-126 Assigned blank blank Transitory state for BRI endpoints
and ASAI adjuncts. The switch
attempts link establishment.
1. Check endpoints and wiring b y
following SPID Facility Test
Procedures described in the
BRI-SET (ISDN-BRI Set/ASAI
Adjunct) Maintenance
documentation.
2. Verify repairs with status
bri-port PCSSpp. Determine
that L2 state of the signaling link
is “L3-Established” for ASAI
adjuncts and BRI endpoints
supporting MIM (management
information messages)
initialization and “Established”
for fixed TEIBRI endpoints and
automatic TEIBRI endpoints not
supporting MI M initialization.
NOTE:
A MIM is a level-3 message
that conveys management
and maintenance information
between communications
systems and BRI terminals.
Continued on next page