DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-163ATM-EI (Expansion Interface Circuit Pack)
3
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of tone detectors present, or some tone
detectors may be out of service.
1. Resolve any TTR-LEV errors. Even if there are not TTR-LEV errors,
there may not be a tone detector available on the network that
contains the circuit pack being tested. Verify that there is at least one
tone detector on this network. If not, this test always aborts for this
ATM-EI circuit pack, but does not harm the system.
NOTE:
DEFINITY Systems require that Tone Clock circuit packs (TN2182)
must be of vintage “B” or newer. If older Tone Detector circuit
packs are installed in the system, this test always aborts with this
abort code.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the command at 1-minute intervals a
maximum of 3 times.
1033 ABORT The test cannot run because either the ATM-EI board is not
administered, or there were no other PNs administered that had its
ATM-EI board in-service.
1. Ensure that the board is administered as ATM PNC Expansion
Interface circ uit pack.
If the board is administered as ATM-EI circuit pack, then there has
been some change in the ability of the ATM-EI circuit pack in the
other PNs to communicate with the ATM-EI on the other end of its
connection.
2. Using status port
x
(the port-network number in which the board is
administered), see if both ACL and EAL are up to this board. If they
are not, see the service procedure for SYS-LINK.
3. Check the Error Log for Error Type 1281 with Aux Data 27 (board
cannot talk to the ATM switch). See Table 3-65 for repair procedures.
If present, check both the ATM switch and the DEFINITY
administrations for consistent ATM addresses. Reset the board and
see if the problem resolves.
4. Repeat Test #241. If it continues to abort with this abort code,
replace the board.
Table 3-67. Expansion Interface 2-way Transmission Test (#241) — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page