DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-1097TIE-DS1 (DS1 Tie Trunk)
3
Conference Circuit Test (#7)
One or more NPEs reside on each circuit pac k with a TDM Bus interface. The
NPE controls port connectivity and gain, and provid es conferencing func tions on
a per-port basis. The Conferenc e Circuit Test verifies that the NPE channel for the
port being tested can correctly p erform the conferencing func tion. The NPE is
instructed to listen to several d ifferent tones and conference the tones tog ether.
The resulting signal is then measured b y a Tone Detector port. If the level of the
tone is within a certain range, the test p asses.
Table 3-487. TEST #7 Conference Circuit Test
Error
Code
Test
Result Description/ Recommendation
ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000 ABORT System resources required to run this test were not availab le. The port may
be busy with a valid call. Use the display port PCSSpp command to
determine the trunk group/member number of the port. Use the status
trunk command to determine the service state of the port. If the service
state indicates that the port is in use, then the po rt is unavailable for certa in
tests. You must wait until the port is idle before retesting.
1. If the port status is active but the port is not in use (no calls), check the
error log for error type 1025 (see the error log table for a description of
this error and required actions). The port may be locked up.
2. If the port status is idle, retry the command at 1-minute intervals for a
maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out of service due
to TDM-BUS errors. The status health command can be used to
determine if the system is experiencing heavy traffic. Refer to the
TDM-BUS (TDM bus) Maintenance Documentation to diagnose any active
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic
and the port status is idle, retry the command at 1-minute intervals for
a maximum of 5 times.
Continued on next page