DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-659ETR-PT (Enhanced Tone Receiver Port)
3
1003 ABORT The system could not allocate a Tone-Clock for the test connection. This
may be caused by a heavy load on the system or by a faulted Tone-Clock.
1. Check to see if there are any alarms against the Tone-Clock in the port
network where the test aborted. If so refer to the recommended
procedures for TONE-BD or TONE-PT.
2. If a new Tone-Clock has been inserted, allow about 1 minute for
maintenance to run on the newly inserted circuit pack.
3. Retry the command at 1-minute intervals a maximum of 5 times.
2000 ABORT Circuit Pack’s response to the test request was not received within the
allowable time period.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2006 ABORT This abort code indicates that the active Tone-Clock circuit pack or a Tone
Detector circuit pack may not be functioning properly. On G3r V2 systems,
this abort can also be caused by a mismatch between the c ompanding
mode administered for the system and that of the Tone Detector circuit
pack.
1. [G3r V2] Make sure that the companding mode of the system matches
that of the Tone Detector: mu-law for TN748; A-law for TN420.
2. Test the
active
Tone-Clock circuit pack in the port network with the test
tone-clock PC command and refer to the TONE-BD section for
failures.
3. Retry the command at 1-minute intervals a maximum of 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1-122 FAIL DTMF digits were not detected correc tly.
1. Run the short test sequence via the test port PCSSpp sh r 1
command.
2. If the problem persists, the system is still operating properly but
capacity will be reduced . To restore performance to normal, replace
the circuit pack containing the defec tive ETR-PT (Enhanced Tone
Receiver Port). Follow the procedures described in the TONE-BD
section for replacing a tone/clock circuit p ack.
Table 3-273. TEST #42 Tone Detection Verification Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page