DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-905PKT-INT (Packet Interface)
3
Table 3-388. TEST #884 Memory Checksum Test
Error
Code
Test
Result Description/ Recommendation
1006
1137 ABORT Packet Interface is in the out-of-service state so normal maintenance tests
will not run.
1. Use the
display system-parame ters maintenance
command to
identify which C-LAN ci rcuit pack is administered w ith the Bus
Bridge. Verify that the C-LAN circuit p ack is present and is not
alarmed.
2. Request a Packet Interface reset using th e reset
packet-interface AS command. Refer to the Packet Interfa ce
Reset Test (#889) repair procedures for further action.
1334 ABORT The Packet Interface command queue is full. This should be a temporary
condition caused by a high rate of command s being sent to a Packet
Interface. Continued op eration with a full command q ueue will cause a
system WARM restart that may escalate to more severe restart levels.
1. Retry the command at 10-second intervals, a maximum of 5
times.
2000 ABORT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals, a maxi mum of 3 times.
2500 ABORT Internal system error.
1. Retry the command.
NO
BOARD The Packet Interface is not detected as being physically present.
1. Reboot the system, then retry the command. If the NO BOARD
indication persists, rep lace the TN798 Processor circuit pac k.
1537 FAIL The Boot PROM memory checksum test failed. The Packet Interface may still
be operational.
1. Retry the command.
2. If the same error code occ urs, replace the TN798 Processor
circuit pack a t a time that would cause the least disrup tion of
service. The Packet Interface is still func tional but should be
replaced sinc e it may not operate after a system reboot and it will
enter a fatal fault state if it is reset for other reasons.
Continued on next page