DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-847MMI-PT
3
Error Log Entries and Test to Clear Values
Notes:
a. The customer endpoint co nnected on a conferenc e sent too many
messages to the VSP-MCU in a specified amount of time. Chec k the
“status conference” forms to correlate which c ustomer had the problem.
This is a cus tome r end poi nt pr oble m and not a VSP-MCU prob lem.
b. This port has been busied out by the busyout port PCSSpp command.
c. Indicates that the c ircuit pack has b een removed or has been insane for
more than 11 minutes. To clear the error, replace or reseat the circuit pack.
d. This error occurs if the MMI circuit p ack detects a DSP Error. Maintenance
software will reset the DSP when this error is received. This error is logged
for all 8 resources connected to this particular DSP. If this DSP continues
to fail sanity, a Minor alarm is raised. Replace the c ircuit pack.
e. This error occurs when the Resource Looparound Test (#1111) fails. Run
the Long Test Sequence and note the results of Test #1111.
f. This error occurs if either the MMI or Voice Conditioner (VC) circ uit packs
reports a loss of framing on the service c hannel between these two circuit
packs. When a customer endp oint establishes a call to the VSP-MCU, a
channel is established b etween the MMI resource and the VC por t. If this
channel is detected to go down by either c ircuit pack, an up link message
is sent. This error is then forwarded to maintenance for both c ircuit packs.
Table 3-367. MMI-PT Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/ Off
Board Test to Clear Value
01
1. Run the short test sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommend ed procedures.
0 Any Any Any test port PCSSpp sh r 1
1 (a) Any Uplink error from pack
18 (b) 0 Bus yout p ort PC SSpp WNG OFF releas e por t PCSSpp
130 (c) Any Software generated WNG ON
257 (d) Any None MAJ/
MIN ON
513 (e) Any Resource Loopb ack
Test (#1111) MIN ON test port PCSSpp sh r 3
1025 (f) Any Uplink error from pack
3841 -
3844 (g) Any Uplink error from pack