DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-384CO-DS1 (DS1 CO Trunk)
3
DS1 CO Dial Tone Seizure Test (#314)
DS1CO Dial Tone Seizure Test checks the trunk’s signaling capability p rovided
by the DS1 Interface circuit pack. The maintenance software initiates the test b y
sending a "seizure" message to the DS1 Interface ci rcuit pack and exp ects an
"active" reply from the DS1 interface circuit pac k. If the "active" message is
received, then the test passes. If n o message is received and the timer expires,
the test is aborted. If the DS1 Interface c ircuit pack send s a "reorder" message
back to maintenance software, then th e test fails.
The tes t CANNOT be run on a trunk if one of the foll owing cases is true:
a. The trunk direction is administered as an incoming only trunk.
b. The trunk has been seized b y a normal trunk call.
c. The trunk is administered with maintenanc e test disabled.
0NO
BOARD The test could not relate the internal ID to the port (no board). This result
could be due to incorrect translations, no board is inserted, an incorrect
board is inserted, an insane board is inserted, or the board is hyperac tive
(see note below).
1. Check to ensure that the board translations are correct. Use the list
config command, and resolve any problems that are found.
2. If the board was found to be correctly inserted in step 1, issue the
busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command.
This should re-establish the linkage between the internal ID and the port. If
this is not the case, dispatch to check to ensure that there is a valid board
inserted.
Hyperactivity c auses some special p roblems with the sequenc e suggested
above. If the ports are translated after issuing the list config command but
the Vintage field reports that there is no board (whe n t here really is a
board), then the busyout board and the release busy board commands
will not work (even though the reset board command will work). The
software puts the hyperactive board back in service after the hyperactivity
clears.
Table 3-169. TEST #36 Port Audit and Update Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page